Beijer-electronics EPC LX nautic EN User Manual download pdf (Page 12)

0-12

2.2 Grounding diagram

In order to reliably prevent electrical disruptions,

please note the following points:

• Connect the PC and control cabinet as close to a central grounding

point as possible.

• Make sure inductive connection between the computer and the

control cabinet is as low as possible.

• All data cables connected to the computer have to be shielded

cables.

• The shields have to be grounded on both ends. There must be a

low-impedance connection between the connected systems. Rule

out high equalizing currents through the shielding resulting from

potential differences.

• The grounding connection with a green-yellow cable must be de-

signed with at least a 4 mm² cross-section.

2.3 Installation

Installation The industrial PC has to be installed in an HF- impermeable housing or

metal control cabinet.

In order to dissipate the heat emanating from the PC, 100 mm on three

sides of the PC must be kept clear so air can freely circulate.

The PC is assembled by screwing in eight hexagon nuts.

Caution!

Damage to the PC possible!

Front-end IP65 degree of protection is only guaranteed if the sealing sits

correctly on the front plate.

Once installed, 100 mm on three sides of the PC must be kept clear so

air can freely circulate

Caution!

The use of Compact Flash Card’s from different manufacturers can lead

to errors.

When using an internal and external Compact Flash card, only use cards

from the same manufacturer (same type and same size)

2.4 Switch on the PC

Start-up procedure The EPC boots up and loads the operating system.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 32 33

No comments

Beijer-electronics EPC LX nautic EN User Manual Page 12